1. Attaching the right panel
Paso 1 de 21 (Capítulo 4 de 6)
Contenidos
Comentarios
⬢Place the side panel on the printer.
⬢Carefully insert the short PTFE tube from the filament sensor through the opening in the side cover handle.
⬢Fix the side panel in place using 11x nylon rivets. Push one into each indicated hole, and the rivet will hold the side panel in place.
A spare bag of nylon rivets was included with the upgrade.
⬢Gently pull the PTFE tube and connect it back into the collet. Make sure to insert the tube all the way in.
⬢Place the side panel on the printer.
⬢Fix the side panel in place using 7x nylon rivets. Push one into each indicated hole, and the rivet will hold the side cover in place.
Contenidos
Prusa CORE One L to CORE One L+ upgrade [Traducción en desarrollo]
- 1. Introduction
- 2. Preparing the printer
- 3. Belts upgrade
- 4. Assembling the Nextruder [Traducción en desarrollo]
- Attaching the right panel
- Securing the PTFE tube
- Installing the LoveBoard assembly
- Attaching the fan shroud
- Connecting the main cable
- Attaching the print fan
- Attaching the Nextruder assembly
- Attaching new hotend fan
- Securing the PTFE tube
- Attaching Printhead-cover-right
- Attaching the Hotend-cable-clip
- Connecting the hotend fan and thermistor cables
- Inserting the hotend
- Checking the nozzle
- Connecting the hotend cables
- Guiding the hotend cables
- Attaching the Printhead-cover-left
- Reconnecting the motor cables
- Covering the electronics
- Attaching the left side covers
- Attaching the printer top cover
- 5. Installing the nozzle wiper
- 6. Preflight check
Comentarios
Inicia sesión para publicar un comentario
Sin comentarios