English
1. Preparing the kit
Step 1 of 14 (Chapter 1 of 10)
Contents
Comments
⬢Welcome to the guide for assembling setting up your Prusa CORE One kit. Follow these steps to ensure your printer is ready for its first print.
⬢Please prepare the kit received from Prusa Research.
No soldering or wire crimping is required.
Contents
Prusa CORE One kit assembly (1.00)
- 1. Introduction
- Preparing the kit
- How to navigate through the manual
- View high resolution images
- All the required tools are included
- Additional utilities for this guide
- Labels guide
- Spare bag
- Printed parts - versioning
- We are here for you!
- Pro tip: inserting the nuts
- Important: Electronics protection
- Reward yourself
- How to successfully finish the assembly
- Prepare your desk
- 2. Base assembly
- 3. Back assembly
- 4. Heatbed assembly
- 5. CoreXY assembly
- 6. Nextruder assembly
- 7. Bodywork & Electronics
- 8. Trim, Door & xLCD
- 9. Calibration & First run
- Manual changelog
Comments
Log in to post a comment
Icythings
•
Seems that on the iPad, the comments don't seem to change with the assembly steps. Had to set up the lap top to read them. Noticed this after looking at the same set of comments till the first dose of haribo.