1. xBuddy Prep
Step 1 of 26 (Chapter 4 of 12)
Contents
Comments
⬢There might be thermal pads stuck to the rear of the xBuddy board. Remove the thermal pads and clean up any glue residue.
Do not use sharp object to remove the pads.
Contents
Prusa CORE One+ (Gen 2) conversion kit (1.00)
- 1A. Introduction
- 1B. MK4S Inspection
- 1C. Printer Dissasembly
- 1D. Component Prep
- xBuddy Prep
- xLCD Disassembly
- xLCD Disassembly 2
- Print Fan Prep
- Y Motor Prep
- Y Motor Prep 2
- X Motor Prep
- Z Motor Prep
- Heatbed Prep
- Heatbed Prep 2
- Thermistor Prep
- Thermistor Installation
- Thermistor Installation 2
- Thermistor Installation 3
- Heatbed Rework
- Gearbox Cover Preparation
- Nextruder Rework
- Nextruder Rework 2
- Bearings Check
- Parts Check
- Parts Recap 1
- Parts Recap 2
- Parts Recap 3
- Parts Recap 4
- Parts Recap 5
- Parts Recap 6
- 2. Base assembly
- 3. Back assembly
- 4. Heatbed assembly
- 5. CoreXY assembly
- 6. Nextruder assembly
- 7. Bodywork & Electronics
- 8. Trim, Door & xLCD
- 9. Calibration & First run
Comments
Log in to post a comment
No comments