1. Tools necessary for this chapter

Original Prusa Enclosure assembly (1.1)

• 1. Introduction
• 2A. Preparing the printer (MK4/S & MK3.9/S)
• 2B. Preparing the printer (MK3.5 Black PSU)
  1. Tools necessary for this chapter
  2. Preparing the printer
  3. Disconnecting the PSU cables
  4. Cutting off the zip-ties
  5. Removing the cable clips
  6. Releasing the PSU cables
  7. Guiding the cables: parts preparation
  8. Guiding the cables
  9. Guiding the cables
  10. Placing the printer
  11. Releasing the PSU
  12. Mounting the printer frame support: part preparation
  13. Mounting the printer frame support
  14. Covering the PSU cables: parts preparation
  15. PSU cables
  16. Covering the PSU cables
  17. Removing the FS-cover
  18. Installing the new FS-cover: parts preparation
  19. Installing the new FS-cover
  20. Haribo time!
  21. The printer is prepared
• 2C. Preparing the printer (MK3S+ Black PSU)
• 2D. Preparing the printer (MK3S+ Silver PSU)
• 3. Assembling the enclosure
• 4A. Installing the printer (MK4/S & MK3.9/S)
• 4B. Installing the printer (MK3.5 Black PSU)
• 4C. Installing the printer (MK3S+ Black PSU)
• Fire Suppression System (add-on)
• 4D. Installing the printer (MK3S+ Silver PSU)
• Hinged Lid (add-on)
• Hinged Lid with MMU3
• Hinged lid with MMU2S
• Advanced filtration system (add-on)
• Mechanical lock (add-on)
• Quick release PSU cable - MK3S+ Black PSU (add-on)
• Quick release PSU cable - MK4/3.9 Black PSU (add-on)
• White LED strip (add-on)
• Manual changelog Enclosure