⬢For this chapter, please prepare:
⬢2.5mm Allen key
EN
Login- Español
- Deutsch
- Polski
- Français
- Home
- CORE One
- Assembly manuals
- Prusa CORE One (assembled)
- 3. Mounting the xLCD
3. Mounting the xLCD
Menu
- Prusa CORE One (assembled)
- 1. Introduction
- 2. Unpacking the printer
- 3. Mounting the xLCD
- 1. Tools necessary for this chapter
- 2. Removing the bezel
- 3. xLCD assembly: parts preparation
- 4. Connecting the xLCD assembly
- 5. Mounting the xLCD
- 6. Attaching the display assembly
- 7. Peeling off the protectives
- 4. Calibration & First run
- Manual changelog
3. Mounting the xLCD
Relevant for:
Last updated 4 days ago Difficulty
Easy Steps
7 Available languages
⬢Open the door fully.
⬢Lift the right end of the front bezel and unhook it from the printer frame.
⬢Pull the bezel out of the printer. Do not discard the part.
Proceed carefully to avoid scratching the parts or damaging the door.
The bezel is attached to the printer with magnets, making it easy to remove.
⬢Note the cables coming from the printer. We’ll address them shortly. Avoid pushing them into the printer, keep them as they are.
⬢For the following steps, please prepare:
⬢xLCD assembly (1x)
⬢Connect the xLCD cable (gray cable with red connector) to the xLCD board on the back of the xLCD assembly. Do not pull on the cable!
Ensure the latch on the connector is positioned on the same side of the slot as the triangle symbol on the xLCD board. Otherwise, the xLCD won't work.
⬢Take the FE cable and fully slide the metal connector onto the FE Faston (brass connector) on the xLCD board. Do not pull on the cable!
For a better overview of the correct connection of both cables, see the illustrations.
⬢Install the bezel onto the screws on the back of the xLCD assembly.
⬢Ensure the magnets face upward. The bezel has four magnets, but only two are visible in the picture.
⬢Ensure both screws (M3x6) are not fully tightened, leaving approximately a 3 mm (1/8 inch) gap between the screw head and the xLCD cover.
⬢Slide the bezel toward you, ensuring both screws are positioned at the end of the keyhole-shaped holes.
⬢Keep the bezel in position and fully tighten both screws.
⬢Carefully install the display assembly (xLCD and bezel) onto the printer using the following procedure:
Proceed carefully to avoid scratching the parts or damaging the door.
⬢Hook the left side of the bezel onto the left frame of the printer, ensuring the square cutout is securely attached to the frame.
⬢Slowly lower the right side into place as well.
⬢Secure the right side of the bezel onto the right frame of the printer, ensuring the square cutout is securely attached to the frame.
⬢Ensure the bezel is evenly seated at both ends along the bottom edge — test it by closing the door slowly to check if the bezel obstructs movement.
⬢Now, you can remove the protective films from the transparent panels on the printer.
⬢The protective film is located on the top, left, and right sides of the printer.
⬢We are almost there! Let's go to the last chapter: 4. Calibration & First run
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.