English
1. Tools necessary for this chapter
Step 1 of 40 (Chapter 4 of 10)
Contents
Comments
⬢For this chapter, please prepare:
⬢Needle-nose pliers
⬢Universal wrench
⬢Wrench 13-16
⬢Philips (PH2) screwdriver
⬢2.5mm Allen key
⬢2.0mm Allen key
⬢T10 torx key / T10 torx screwdriver
Contents
Prusa CORE One kit assembly (1.00)
- 1. Introduction
- 2. Base assembly
- 3. Back assembly
- 4. Heatbed assembly
- Tools necessary for this chapter
- Heatbed: parts preparation
- Heatbed cable assembly (part 1)
- Heatbed cable assembly (part 2)
- Bed-cable-cover-bottom: parts preparation
- Attaching the cable cover
- Heatbed carriage: parts preparation
- Preparing the heatbed carriage
- Installing the expansion joints
- RGB LED strip: parts preparation
- Installing the LED strip
- Attaching the LED strip diffuser
- Covering the RGB LED strip
- Guiding the RGB LED strip cable
- Bed mounts: parts preparation
- Assembling the bed mounts
- Securing the bed mounts
- Bed mounts: inserting the nuts
- Assembling the CORE-One-bed-spacer-rear
- Installing the bed-mount-right
- Installing the bed-mount-left
- Mounting the heatbed: parts preparation
- Mounting the heatbed
- Tightening the heatbed
- Covering the cables: parts preparation
- Guiding the heatbed cables
- Covering the heatbed cables
- Mounting the heatbed: parts preparation
- Attaching the heatbed assembly
- Mounting the heatbed assembly: rear motor
- Mounting the heatbed assembly: front motor left
- Mounting the heatbed assembly: front motor right
- Attaching the heatbed cables I.
- Attaching the heatbed cables II.
- Securing the heatbed cables: parts preparation
- Securing the textile sleeve
- Guiding the heatbed assembly cables
- Connecting the heatbed power cables
- Haribo time
- Done
- 5. CoreXY assembly
- 6. Nextruder assembly
- 7. Bodywork & Electronics
- 8. Trim, Door & xLCD
- 9. Calibration & First run
- Manual changelog
Comments
Log in to post a comment
No comments