1. Textile sleeve vs spiral wrap
Step 1 of 50 (Chapter 7 of 14)
Contents
Comments
Before you proceed further ensure again, you are in the correct chapter:
⬢The longest and biggest sleeve is a textile sleeve. If so, you can proceed according to this chapter.
⬢If the longest and biggest sleeve is a spiral wrap, please use this chapter instead: 5. E-axis assembly (spiral wrap)
Contents
Original Prusa i3 MK3 kit assembly
- 1. Introduction
- Introduction
- 2. Y-axis assembly
- 3. X-axis assembly
- 4. Z-axis assembly
- 5. E-axis assembly (spiral wrap)
- 5. E-axis assembly (textile sleeve)
- Textile sleeve vs spiral wrap
- Tools necessary for this chapter
- Idler assembly (part 1)
- Idler assembly (part 2)
- Idler assembly (part 3)
- Assembling filament sensor (part 1)
- Assembling filament sensor (part 2)
- Assembling filament sensor (part 3)
- Assembling filament sensor (part 4)
- Extruder assembly - idler (part 1)
- Extruder assembly - idler (part 2)
- Assembling the Extruder motor pulley (part 1)
- Assembling the Extruder motor pulley (part 2)
- Mounting the Extruder motor
- Adjusting and tightening the pulley
- Securing the Extruder idler
- Preparing hotend and extruder-cover
- E3D V6 hotend - different versions
- Inserting the E3D hotend
- Preparing the extruder-cover
- Mounting point for the Extruder body
- Mounting the extruder-cover
- Preparing cooling fans
- Mounting the left hotend fan
- Mounting the front print fan - parts B7/R3
- Mounting the front print fan - parts B7/R3
- Mounting the front print fan
- Preparing the P.I.N.D.A. probe
- Mounting the P.I.N.D.A. probe
- Extruder cables preparation
- Mounting the Extruder
- Cable for the filament sensor
- Connecting the Filament sensor
- Preparing the NYLON filament
- Inserting the NYLON filament
- Preparing the X-carriage-back (part 1)
- Preparing the X-carriage-back (part 2)
- Preparing the X-carriage-back (part 3)
- Preparing the X-carriage-back (part 4)
- Assembling the X-carriage-back
- Adjusting the filament sensor cable
- Mounting the X-carriage-back
- Tightening the textile sleeve (part 1)
- Tightening the textile sleeve (part 2)
- Tightening the textile sleeve (part 3)
- Mounting the Filament-sensor-cover (part 1)
- Mounting the Filament-sensor-cover (part 2)
- Mounting the Filament-sensor-cover (part 3)
- Assembling the idler-plug
- E-axis is finished!
- 6. LCD assembly
- 7. Heatbed & PSU assembly (spiral wrap)
- 7. Heatbed & PSU assembly (textile sleeve)
- 8. Electronics assembly (B3/R2 design)
- 8. Electronics assembly (B7/R3 design)
- 9. Preflight check
- Manual changelog
Comments
Log in to post a comment
No comments