English
1. Tools necessary for this chapter
Step 1 of 45 (Chapter 5 of 9)
Contents
Comments
⬢For this chapter, please prepare:
⬢1.5mm Allen key
⬢2.5mm Allen key
⬢Torx key TX6
⬢Torx key TX10/8
⬢Needle-nose pliers
⬢Permanent marker
Contents
Original Prusa MK4 kit assembly (1.01)
- 1. Introduction
- 2. Frame assembly
- 3. X-axis & X-carriage assembly
- 4. Z-axis assembly
- 5. Nextruder assembly
- Tools necessary for this chapter
- Filament sensor: parts preparation
- Assembling the filament sensor
- Installing the filament sensor
- Nextruder idler assembly: parts preparation
- Assembling the extruder idler
- Assembling the extruder: parts preparation I.
- Assembling the extruder: parts preparation II.
- Assembling the extruder
- Assembling the gearbox
- Assembling the PG-ring
- Assembling the PG-assembly
- Checking the PG-assembly
- Assembling the Nextruder idler
- Covering the planetary gear
- Assembling the Idler-swivel: parts preparation
- Assembling the Idler-swivel
- Assembling the Idler-nut
- Mounting the Idler-swivel assembly
- Attaching the extruder: parts preparation
- Assembling the heatsink
- Attaching the extruder
- Connecting the NTC thermistor
- Assembling the hotend fan: parts preparation
- Assembling the hotend fan
- Inserting the hotend assembly: parts preparation
- Inserting the hotend assembly
- Connecting the hotend cables
- Assembling the fan-door: parts preparation
- Assembling the fan-door: mounting fan
- Assembling the fan-door: assembling fan-shroud
- Preparing the fan-door
- Attaching the fan-door: inserting magnet
- Attaching the fan-door
- Connecting the extruder cables
- Connecting the print fan
- LoveBoard: Wiring check
- Covering the LoveBoard: parts preparation
- Covering the LoveBoard: side cover
- Covering the LoveBoard: top cover
- Tensioning the X-axis belt
- Belt tension check
- Testing the X-axis belt
- Haribo time!
- The extruder is assembled
- 6. xLCD assembly
- 7. Y-carriage & Heatbed assembly
- 8. Preflight check
- Manual changelog MK4 kit
Comments
Log in to post a comment
Kesuaheli
•
"Permanent Marker" has a pink hexagon in the description. But in the 3rd image it has an orange arrow pointing to it. The descripting should have an orange hexagon too, since the 1.5 key is already pink
efvee
•
You need do not do anything with the printer as built up to now until mounting the Nextrudr in step 22.
You will do fine mechanic assmbly work instead.
So: move the printer out of the way and clean your desktop.
You will do fine mechanic assmbly work instead.
So: move the printer out of the way and clean your desktop.