English
Login
3D printers
Materials
Parts & Accessories
Software
3D Models
Applications
Community
Help
Academy
Blog
Company
Support
Original Prusa MMU3
Original Prusa MMU3 Assembly
6. Pulley Body Assembly | Tools necessary for this chapter
1. Tools necessary for this chapter
Step 1 of 40 (Chapter 6 of 15)
Fullscreen mode
Contents
Comments
⬢
Please prepare tools for this chapter:
⬢
Needle-nose pliers
⬢
1.5mm Allen key for nut alignment
⬢
2.5mm Allen key for M3 screws
⬢
A measurement tool (optional), a digital caliper would work the best.
Loading...
Next
Contents
Original Prusa MMU3 Assembly
1. Introduction
2. MMU2S Disassembly (UPG)
3. MMU2S Buffer Disassembly (UPG)
4. Idler Body Assembly
5. Selector Assembly
6. Pulley Body Assembly
Tools necessary for this chapter
Pulley-body parts preparation
Pulley body: Inserting bearings
Pulley-body parts preparation
Front-PTFE-holder assembly
Collet holder parts preparation
Collets installation
Collet holder installation
Pulley motor parts preparation
Pulley assembly
Pulley motor assembly (part 1)
Pulley motor assembly (part 2)
Pulley alignment
Selector: parts preparation
Selector installation
Selector movement check / motor prep
Selector motor installation
Trapezoid nut positioning
Idler body installation parts preparation
Idler body installation (part 1)
Idler body installation (part 2)
Idler body installation (part 3)
Control board parts preparation
Control board assembly
PD-board parts preparation
Installing the PD-board-cover
PD-board installation
Connecting the cables
Electronics assembly
Textile sleeve parts preparation
Cable management (part 1)
Cable management (part 2)
Frame holders parts preparation
Frame holders assembly
Label plate installation
Rear PTFE parts preparation
Rear PTFE installation
Setting the Idler tension
Stickers parts preparation
Applying the stickers
7. Cassette Buffer Assembly
8. Spool holder Assembly
9A. MK4/S, MK3.9/S Nextruder mod
9B. MK3S+ / MK3.5 Extruder mod (KIT)
9C. MK3S+ Extruder (UPG)
10A. MK4/S, MK3.9/S Setup and Calibration
10B. MK3S+ Setup and Calibration
10C. MK3.5 Setup and Calibration
11. First Flight
Comments
Log in
to post a comment
Gregor_PRIV
•
8 months ago
Prusatoyo
... Well done 🤣👍
Reply
