English
Prusa Connect & PrusaLink
Comments
Contents
- Wi-Fi and Prusa Connect/Link setup (CORE One, MK4/S, MK3.9, MK3.5, XL, MINI/+)
- Adding the printer to Prusa Connect (CORE One, MK4/S, MK3.9/S, MK3.5/S, XL, MINI/+)
- Camera setup for PrusaLink / Prusa Connect
- Prusa Connect - Telegram notifications setup
- Prusa Connect - Discord notifications setup
- Prusa Connect - Slack notifications setup
- ESP Camera for Prusa Connect
Comments
18 comments
Log in to post a comment
Martin
•
My Prusa lost the connection to the wifi network, and was not able to recover.
After resetting the printer, the wifi-setup immediately pop-ups and asked for configuration. (Strange, because it was already setup). Nevertheless tried to load the credentials from stick. But printer was not able to connect.
Then I tried to reflash the wifi-module firmware. It immediately failed.
Just by completely powering off the printer from the electricity and waiting a few seconds before I powered the machine on.
After the power-up was done, the module was responsive again, and I could continue printing through the wifi-connection.
After resetting the printer, the wifi-setup immediately pop-ups and asked for configuration. (Strange, because it was already setup). Nevertheless tried to load the credentials from stick. But printer was not able to connect.
Then I tried to reflash the wifi-module firmware. It immediately failed.
Just by completely powering off the printer from the electricity and waiting a few seconds before I powered the machine on.
After the power-up was done, the module was responsive again, and I could continue printing through the wifi-connection.
David B.
•
Hello! If this issue persists and isn't a one-time occurrence, it could indicate a hardware problem. Please check the connection of the ESP module to the main board. If you suspect the hardware is faulty, don't hesitate to contact support for a replacement.
Studio Sagan
•
I see a bunch of suggestions for editable passwords. If I might add to that, please allow us to change the hostname. When connected over a wired connection my device shows up as prusaMINI, but on wifi there is no name at all. My home network uses custom DHCP so this would help in the future. Thanks! ... EDIT: It appears that setting [network] hostname=your_preferred_name in prusa_printer_settings.ini might do this but I haven't tried it yet. ... EDIT2: Confirmed this changes the hostname. See Github for more: https://github.com/prusa3d/Prusa-Firmware-Buddy/blob/master/doc/prusa_printer_settings.ini
Jakub Dolezal
•
Hi, thanks. We have noticed the feedback regarding editable passwords and forwarded this to the devs :)
wmfmontrose
•
This whole process is not intuitive. Nor time well spent. I'll continue with the Nike transfer method. (USB)