1. Tools necessary for this chapter

Bondtech INDX Conversion kit for the Prusa CORE One/+ (Founders Edition)

• 1. Introduction & preparation
• 2. Printer disassembly
  1. Tools necessary for this chapter
  2. Important information - removed parts
  3. Removing the top nylon rivets
  4. Removing the top panel
  5. Removing the top profile
  6. Removing the door
  7. Accessing the electronics
  8. Accessing the buddy board
  9. Unplugging the cable I.
  10. Unplugging the cables II.
  11. Removing the cables
  12. Pushing the cables in
  13. Guiding the heatbed cables in
  14. Releasing the main cable
  15. Removing the LoveBoard cover
  16. Disconnecting the Nextruder cables - left
  17. Disconnecting the Nextruder cables - top
  18. Disconnecting the Nextruder cables - right
  19. Disconnecting the PTFE tube
  20. Removing the Nextruder fitting
  21. Removing the Nextruder
  22. Removing the print fan
  23. Removing the LoveBoard
  24. Removing the fan shroud
  25. Removing the side handle
  26. Removing the side filament sensor
  27. Removing the spoolholder
  28. Parts recap I.
  29. Parts recap II.
  30. Haribo time!
  31. Final step
• 3. Z-axis upgrade
• 4. INDX Toolhead & Side filament sensors
• 5. Spool holders & Tool dock assembly
• 6. Preflight check