1. Tools necessary for this chapter

Prusa INDX Conversion kit for the Prusa CORE One/+ (1.00)

• 1. Introduction
• 2. Printer preparation & disassembly
  1. Tools necessary for this chapter
  2. Important: Update the firmware
  3. Moving the Z-axis
  4. Unloading filament
  5. Powering off & protecting the printer
  6. Disconnect the Buddy3D camera
  7. Do not discard removed parts
  8. Removing the top nylon rivets
  9. Removing the top panel
  10. Removing the top profile
  11. Removing the door
  12. Accessing the electronics
  13. Accessing the buddy board
  14. Unplugging the cable I.
  15. Unplugging the cables II.
  16. Removing the cables
  17. Pushing the cables in
  18. Guiding the heatbed cables in
  19. Releasing the main cable
  20. Removing the LoveBoard cover
  21. Disconnecting the Nextruder cables - left
  22. Disconnecting the Nextruder cables - top
  23. Disconnecting the Nextruder cables - right
  24. Disconnecting the PTFE tube
  25. Removing the Nextruder fitting
  26. Removing the Nextruder
  27. Removing the print fan
  28. Removing the LoveBoard
  29. Removing the fan shroud
  30. Removing the side handle
  31. Removing the side filament sensor
  32. Removing the spoolholder
  33. Parts recap I.
  34. Parts recap II.
  35. Haribo time!
  36. Final step
• 3. Z-axis upgrade
• 4. INDX Toolhead & Side filament sensors
• 5. Spoolholders & Tool dock assembly
• 6. Preflight check