English
Login
3D printers
Materials
Parts & Accessories
Software
3D Models
Applications
Community
Help
Academy
Blog
Company
Support
Original Prusa MINI
Printer maintenance
How to replace a hotend fan (MINI) | Begin assembly
1. Begin assembly
Step 1 of 15 (Chapter 18 of 23)
Fullscreen mode
Contents
Comments
Difficulty
Moderate
Available languages
Begin assembly
Contents
Printer maintenance
How to replace a M.I.N.D.A. sensor (MINI)
How to replace a print fan (MINI)
How to replace a hotend PTFE tube (MINI/MINI+)
How to replace a heatsink (MINI/MINI+)
How to replace a Buddy control board (MINI)
How to access and clean the extruder-pulley (MINI/MINI+)
How to update firmware (MINI/MINI+)
How to replace a print head PTFE tube (MINI/MINI+)
Height adjustment of M.I.N.D.A./SuperPINDA sensor (MINI/+)
How to replace a heatbed (MINI/MINI+)
How to replace an extruder motor (MINI/MINI+)
How to replace SuperPINDA (MINI/MINI+)
How to replace bearings on the X-axis (MINI/MINI+)
How to replace bearings on the Y-axis (MINI/MINI+)
How to replace a heatbed set (MINI/MINI+)
How to replace a heatbed thermistor (MINI/MINI+)
How to replace a hotend thermistor (MINI/MINI+)
How to replace a hotend fan (MINI)
Begin assembly
Introduction
Tools and fasteners necessary for this guide
Additional heatbed protection
Opening the box with the electronics
Removing the textile sleeve (old design)
Removing the hotend fan
Hotend fan - parts preparation
Hotend fan - parts alignment
Hotend fan installation
Guiding the cable bundle
Guiding the cable bundle
Guiding the cable bundle
Connecting the new hotend fan
Covering the electronics
How to replace a hotend heater (MINI/MINI+)
How to replace a heaterblock/heatbreak (MINI/MINI+)
How to post-process the printed parts
How to trim PTFE tube - Original Prusa printers
Replacing the PEI sheet on the (MK3S/MK3/MK2.5S/MK2.5)
Comments
Log in
to post a comment
No comments
