English
Login
3D printers
Materials
Parts & Accessories
Software
3D Models
Applications
Community
Help
Academy
Blog
Company
Support
Original Prusa MINI
Printer maintenance
How to replace bearings on the Y-axis (MINI/MINI+) | Begin assembly
1. Begin assembly
Step 1 of 26 (Chapter 14 of 23)
Fullscreen mode
Contents
Comments
Difficulty
Moderate
Available languages
Begin assembly
Contents
Printer maintenance
How to replace a M.I.N.D.A. sensor (MINI)
How to replace a print fan (MINI)
How to replace a hotend PTFE tube (MINI/MINI+)
How to replace a heatsink (MINI/MINI+)
How to replace a Buddy control board (MINI)
How to access and clean the extruder-pulley (MINI/MINI+)
How to update firmware (MINI/MINI+)
How to replace a print head PTFE tube (MINI/MINI+)
Height adjustment of M.I.N.D.A./SuperPINDA sensor (MINI/+)
How to replace a heatbed (MINI/MINI+)
How to replace an extruder motor (MINI/MINI+)
How to replace SuperPINDA (MINI/MINI+)
How to replace bearings on the X-axis (MINI/MINI+)
How to replace bearings on the Y-axis (MINI/MINI+)
Begin assembly
Introduction
Some tips (optional)
Tools necessary for this guide
Preparing the printer
Disconnecting the LCD
Disconnecting the heatbed
Removing the Y-axis belt
Removing the Y-front-plate
New bearings: parts preparation
Lubricating the bearings
Lubricating the bearings
Bearing mount: new vs old design
Removing the bearings (new design)
Correct bearing orientation (new design)
Installing bearings on the Y-carriage (new design)
Removing the bearings (old design)
Correct bearing orientation (old design)
Installing bearings on the Y-carriage (old design)
Installing bearings on the Y-carriage (old design)
Inserting the rods
Mounting the Y-carriage
Installing the belt
Tensioning the Y-axis belt
Mounting the heatbed
It is done!
How to replace a heatbed set (MINI/MINI+)
How to replace a heatbed thermistor (MINI/MINI+)
How to replace a hotend thermistor (MINI/MINI+)
How to replace a hotend fan (MINI)
How to replace a hotend heater (MINI/MINI+)
How to replace a heaterblock/heatbreak (MINI/MINI+)
How to post-process the printed parts
How to trim PTFE tube - Original Prusa printers
Replacing the PEI sheet on the (MK3S/MK3/MK2.5S/MK2.5)
Comments
Log in
to post a comment
No comments
