1. Begin assembly

Printer maintenance

• How to replace the CoreXY plastic parts
• How to install the Nextruder V6 Nozzle Adapter (XL single-tool)
• How to replace the Prusa Nozzle (XL single-tool)
  1. Begin assembly
  2. Introduction
  3. Nozzle Replacement Tool
  4. Tools necessary for this chapter
  5. Preparing the printer
  6. Cleaning the hotend
  7. Protecting the heatbed
  8. Disconnecting the hotend
  9. Removing the hotend
  10. Removing the Prusa Nozzle
  11. Installing the Prusa Nozzle: parts preparation
  12. Installing the Prusa Nozzle
  13. Inserting the hotend
  14. Connecting the hotend
  15. Final check
  16. Setting the nozzle diameter
  17. It's done
• How to replace the Hotend assembly (XL single-tool)
• Packing printer for transport - Original Packing Material (XL)
• How to replace the Prusa Nozzle (XL multi-tool)
• How to replace a Z-axis motor (XL)
• Packing the XL Multi-tool for return - Original Packing material
• How to replace a heatbed tile and a heatbed tile cable (XL)
• How to replace a print fan (XL single tool)
• How to fix Modular bed error (HW solution)
• How to replace trapezoid nuts (XL)
• How to clean the side filament sensor (XL)
• How to change xLCD and xLCD cable (XL single-tool)
• How to replace a Dwarf board (XL multi-tool)
• How to replace Nextruder heatsink (XL Multi-tool)
• How to replace a Dwarf board (XL single-tool)
• How to replace the Hotend assembly (XL multi-tool)
• How to replace a hotend thermistor (XL Single-Tool)
• How to replace a Z-axis linear rail (XL)
• How to replace a profile insert (XL)
• How to replace the hotend fan (XL Multi-tool)
• How to replace a PSU (XL)
• How to replace a hotend heater (XL Single-Tool)
• How to lubricate the coupler pins on Original Prusa XL (Multi-Tool)
• How to replace the tch-profile-insert (XL)
• How to replace the Sandwich Board (XL)
• How to replace the rubber band on Original Prusa XL (Multi-tool)
• How replace the CoreXY Cover Rear (Original Prusa XL)
• How to install the Nextruder V6 Nozzle Adapter (XL Multi-Tool)
• How to replace a XY motor (XL)
• Packing the XL Enclosure for return - Original Packing material
• How to change the belt (XL)
• How to replace the main cable connector cover (XL)
• How to replace the PDU splitter (XL)
• How to replace the print fan (XL multi-tool)
• How to replace trapezoid nuts (XL)
• How to lubricate linear bearing rails (XL)
• How to change the xLCD (XL)
• How to set up a Buddy3D Cam
• How to replace Nextruder heatsink (XL Single-tool)
• How to replace a Nextruder (XL single-tool)