1. Get the necessary tools

Kit da assemblare Original Prusa i3 MK2S

• 1. Introduzione
• 2. Y-axis assembly [Traduzione in corso]
  1. Get the necessary tools
  2. 3D printed parts
  3. Assemble the Y-axis rods
  4. Assemble the Y-axis stage rear
  5. Assemble the Y-axis stage front
  6. Fully assemble the Y-axis stage
  7. Preparing for Y-axis stage
  8. Tighten the sides to the y-axis stage
  9. VIDEO for step 8
  10. Identifying the length of rods
  11. Adjust the length of the Y-axis stage
  12. VIDEO for step 11
  13. Marker identification
  14. Correct bearing orientation
  15. Assemble the Y-carriage
  16. Tighten Y-carriage u-shaped bolts
  17. Assembly of the Y-idler
  18. Tighten the Y-idler
  19. Y-motor-distance assembly
  20. Y-axis motor
  21. Adding the Y-axis endstop
  22. Tightening the Y-axis endstop
  23. Y-axis endstop cable guide
  24. Assemble the Y-belt holder
  25. Assemble the Y-carriage rods
  26. Assemble the Y-axis stage
  27. Tighten the zipties on the Y-axis stage
  28. Assemble the belt on the Y-axis, part 1
  29. Assemble the belt on the Y-axis, part 2
  30. Loosening the motor
  31. Assemble the Y-motor pulley
  32. The Y-axis belt placement
  33. Tighten the Y-axis belt, part 1
  34. Tighten the Y-axis belt, part 2
  35. Tensioning the belt
  36. Video for steps 29-35
  37. Adjust the Y-idler
  38. Adjust the Y-motor-mount part
  39. Tighten the screws in the pulley
  40. The Y-axis stage cable management
  41. Levelling the Y-axis
  42. Secure the axis feet
  43. The Y-Endstop check
  44. Double check the Y-carriage!
  45. All done!
• 3. Assemblaggio asse X
• 4. Assemblaggio asse Z
• 5. Assemblaggio Estrusore
• 6. Assemblaggio LCD
• 7. Assemblaggio Alimentatore & Piano riscaldato
• 8. Assemblaggio dell'elettronica
• 9. Controllo finale