The default print head on the Prusa Pro HT90 is a high-flow print head. This allows a high volumetric rate which will let you print faster. The print head also has a fan control that uses a servo motor.
It is also possible to install a High-temperature print head.
You can identify that the high flow print head is installed when it shows a blue stripe.
Nozzle
The high flow print head comes with a Revo High flow nozzle. Note that this nozzle is not resistant to abrasive filaments, as it is made of brass.
If you wish to print with abrasive filaments, use the Revo ObXidian Nozzle.
The nozzle can be changed by screwing and unscrewing by hand, no tools should be used. For that, follow the instructions here: Nozzle replacement (HT90) [Traducción en desarrollo].
- Recommended cleaning methods:
-
- Cleaning filament
- Warm pull
- Cold pull
- Brass brush for the outside
-
- Non-recommended cleaning methods:
-
- Needle
- Steel wire brush
- Blow torch
-
Inicia sesión para publicar un comentario
Sin comentarios