Removing the zip ties carefully with a tool has been the hardest part thus far (I saved this step for last because I'm Aussie & I like to work backwards ;p). I used a sharp modelling knife with a pointy end to get under the tight zip tie & lever the knife upwards.. Being very carful not to cut myself or cut through a wire.. The wire cutters pointy nose wire cutters were of no use
In the prusa settings on the printer there is an option for unload filament, using this I was able to pull it right out easily. Hope this helps someone else that is newbie like I was. What it does is heats up the hotend so that it can be pulled out, it warns you with a beep when to take it out.
I think the Z-Axis Screws need to be turned to move X above Einsy-case. Especially if X is all the way to left side, the cable bundle will be in the way to open door.
