English
1. Tools necessary for this chapter
Step 1 of 64 (Chapter 2 of 9)
Contents
Comments
⬢For this chapter please prepare:
⬢2.0mm Allen key
⬢2.5mm Allen key
⬢3.0mm Allen key
⬢Needle-nose pliers
⬢Universal wrench
Contents
Original Prusa MINI+ kit assembly (v1.1)
- 1. Introduction
- 2. YZ - axis assembly
- Tools necessary for this chapter
- Y-carriage: parts preparation
- Y-carriage: parts preparation (lubricating)
- Lubricating the bearing
- Lubricating the bearing
- Correct bearing orientation
- Installing bearings on the Y-carriage
- Heatbed spacers: parts preparation
- Installing the heatbed spacers
- Y-axis front: parts preparation
- Comparison of extrusions
- Mounting the Y-plate-front
- Mounting the MINI-Y-plate-front
- Y-belt-idler: parts preparation
- Preparing MINI-Y-belt-idler
- Preparing MINI-Y-belt-idler
- Mounting the MINI-Y-belt-idler
- Y-axis smooth rods: parts preparation
- Assembling the Y-carriage
- Mounting the Y-carriage
- Y-axis rear: parts preparation
- Y-axis motor assembly
- Mounting the Y-motor
- Mounting the MINI-Y-rear-plate
- Anti-vibration pads: parts preparation
- Anti-vibration pads installation
- Y-axis belt parts
- Y-axis belt guidance
- Aligning the Y-axis belt
- Y-belt tensioning
- Belt tension check
- Y-axis assembly: reward yourself!
- MINI-Z-bottom: versions
- MINI-Z-bottom: parts preparation
- Assembling the MINI-Z-bottom
- Assembling the MINI-Z-bottom
- Buddy board: parts preparation
- Mounting the Buddy board
- LCD cable: parts preparation
- Connecting the LCD cable
- LCD cable guidance
- Z-axis: parts preparation
- Assembling the Z-axis
- Assembling the Z-axis
- Assembling the Z-axis
- Connecting the Y and Z-axis
- Joining the Y and Z-axis together
- Joining the Y and Z-axis together
- Aligning the YZ-axis assembly
- Securing the YZ-axis assembly
- Guiding the Y-axis motor cable
- Y-axis motor cable guidance
- Z-top: parts preparation
- Assembling the MINI-Z-top
- Assembling the MINI-Z-top
- Z-axis smooth rods: parts preparation
- Mounting the Z-axis smooth rods
- Installing the Z-axis bearings
- Mounting the MINI-Z-top assembly
- Mounting the MINI-Z-top assembly
- Plastic cover: parts preparation
- Securing the MINI-Z-top assembly
- YZ-axis assembly: reward yourself!
- YZ-axis is finished!
- 3. X-axis & Extruder assembly
- 4. Print head & Heatbed assembly
- 5. LCD assembly & Electronics
- 6A. Spool holder assembly
- 6B. Spool holder assembly
- 7. Preflight check
- Manual changelog MINI+ kit
Comments
Log in to post a comment
Same Old Shane
•
Step 3 is a small tube of lubricant, its would be considered a product used for the assembly and itsn't a tool.
nietofarias
•
My Allen keys have different height than the ones in the picture.. My T10 key isn't the tallest.
Don't guide on that parameter.. the T10 is the only different one, for torx screws. Allen's are all hexagonal
Don't guide on that parameter.. the T10 is the only different one, for torx screws. Allen's are all hexagonal