Relevant for
The printer can detect if a loaded G-code is not compatible with the current printer setup, thanks to a set of saved hardware settings. In this scenario, the printer shows the message "The G-code isn't fully compatible".
Error name: The G-code isn't fully compatible
Error code: #31803 (CORE One) #35803 (CORE One L) #26803 (MK4S) #27803 (MK3.9S) #28803 (MK3.5S) #13803 (MK4) #21803 (MK3.9) #23803 (MK3.5) #17803 (XL) #12803 (MINI)
Ensure full compatibility between the G-code and the printer. In particular, double-check both the G-code and the printer hardware settings in LCD Menu -> Settings -> Hardware, for differences in the printer model, the parameters of the installed nozzle, and other hardware settings.
33 comments
Switching back to 6.5.7 allowed me to print multi materails with a manual filament change
6.5.8 gives error not enough extruders detected.
Please revert correct behaviou swith only one physical extruder and manual changes
Is this issue expected to be fixed in the next update?
I also noticed another problem related to the startup G-code. Previously, when loading new filament through the side filament sensor, the printer would automatically move the Nextruder to the front once the filament was detected. With the current firmware, this no longer happens, although it worked correctly in version 6.5.7.
The problem is that the purge process now takes place wherever the Nextruder happens to be when the filament is loaded. This effectively makes accessories such as the purge bin useless, since the purge material is no longer directed to the intended location.
Has anyone else noticed this behavior, and is it also planned to be addressed in a future update?
I’m trying to print using two virtual extruders.
Reinstalling firmware 6.5.7 restores normal operation.
I rolled back to 6.5.7 and works fine. I'm guessing that newer firmwares account for INDX tools so virtual single extruder multimaterial with M600 is now broken.
Prusa please for a workaround ?
Seeing the below warning when trying to send it for printing via Connect
The G-code isn't fully compatible
Detailed instructions are at knowledge base