Stuck filament detection #26101 (MK4S) #13101 (MK4) #21101 (MK3.9) #17108 (XL)

Relevant for:

XL MK4 MK3.9 MK4S

Last updated 2 months ago

This article is also available in following languages:

The Original Prusa MK4/S, MK3.9, and XL are equipped with a loadcell. Thanks to this component, starting from firmware 6.0.0, the printer is able to detect whether the filament is stuck and not moving, for example when the nozzle is clogged.

In case this is detected, the print pauses and the printer shows the message: "Stuck filament detected. The filament seems to be stuck, please unload it from nextruder and load it again".

Once the unload button is pressed, the printer unloads the filament. After this, the printer prompts filament loading, and resumes the print.

It is important to note that detecting stuck filament is possible only inside the Nextruder, as pressure builds up from the nozzle to the upper part of the Nextruder. However, if your filament is tangled on the spool, there will be no internal pressure, just outside tension, which the loadcell won't be able to recognize.

Stuck filament detection won't be possible on MK3.5 and MINI/MINI+ as they aren't equipped with the loadcell sensor.

Screenshot from the Original Prusa MK4

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.